Stamping paint - mART Silver, 11 ml

Attached is a video tutorial on working with stamping and a video about stamping, paint and stamps.

mART stamping instructions:

1. Apply some paint to the plate.

2. Take the die and in a rolling motion, without applying too much pressure, roll the die over the plate.

Important : The rolling motion only needs to be done once!

3. Remove excess paint with a scraper. Hold the scraper at a 45-degree angle and with a quick, steady motion, slide the scraper over the surface of the plate.

Important : the pressure on the scraper should be moderate. Pressing too hard will poorly distribute the paint over the selected pattern, too weak will not remove all the excess. You can use the scraper a second time, but be aware that the paint can dry, so you need to act quickly.

4. Now the drawing on the stamp. At this stage, you can carefully remove unnecessary details of the pattern from the stamp with a toothpick, if necessary.

5. With a rolling motion, without strong pressure, transfer the pattern from the stamp to the nail.

Tip : If you don't like the result, you can remove the stamping with a sticky roller (these are sold for removing dust and hair from clothes) and try again.

6. Cover the nail with top coat.

Tips from mART:

To clean the plate and die you will need:

nail polish remover

lint-free wipes

sticky tape or scotch tape

Clean the plates with lint-free wipes dipped in nail polish remover, with a small amount of acetone and without oils, or use gel polish remover.

It is better to clean the stamp with ordinary adhesive tape with the sticky side.

Alcohol is not suitable for cleaning acrylic plates.

Let the plate dry after rubbing, otherwise the pattern will be slightly "floated".

Plates must be cleaned from previous use.

Use paint with dense pigmentation.

Observe the temperature in the room so that the paint does not dry out too quickly.