Metal plate for stamping "mART-026"

mART metal plates are used as a stencil for transferring the design to the nail, this technology is called Stamping, and to work with this technique you will need: Stamping paint or gel paint , silicone stamp and stamping board .

mART stamping boards are made of high quality metal and have the correct notch depth , which will help to make a clear drawing, even the thinnest lines.

Plate size: 6*12cm

Attached is a video tutorial on working with stamping and a video about stamping, paint and stamps.

mART stamping instructions:

• Apply paint or stamping gel paint to the plate.
• Remove excess paint with a scraper. Hold the scraper at a 45-degree angle and with a quick, steady motion, slide the scraper over the surface of the plate.
  

Important: the pressure on the scraper should be moderate. Pressing too hard will poorly distribute the paint over the selected pattern, too weak will not remove all the excess. You can use the scraper a second time, but be aware that the paint can dry, so you need to act quickly.

• Take the stamp and with a rolling motion, without strong pressure, roll the stamp over the plate.
  

Important: The rolling motion only needs to be done once!

• Now the drawing on the stamp. At this stage, you can carefully remove unnecessary details of the pattern from the stamp with a toothpick, if necessary.
  
• With a rolling motion, without strong pressure, transfer the pattern from the stamp to the nail.
  

Tip: If you don't like the result, you can remove the stamping with a sticky roller (these are sold for removing dust and hair from clothes) and try again.

• Cover the nail with a top coat.
  

Tips from mART:

• To clean the plate and stamp, you will need: nail polish remover and lint-free wipes, a roller with adhesive tape or adhesive tape.
• Clean the plates with lint-free wipes soaked in nail polish remover.
  
• It is better to clean the stamp with ordinary adhesive tape with the sticky side.
  

Alcohol is not suitable for cleaning acrylic plates.

• Let the plate dry after rubbing, otherwise the pattern will be slightly "floated".
  
• Plates must be cleaned from previous use.
  
• Use paint with dense pigmentation.
  
• Observe the temperature in the room so that the paint does not dry out too quickly.